Medi Genumedi Patella Knee Brace
Medi Genumedi Patella Knee Brace
Medi Genumedi Patella Knee Brace
Medi Genumedi Patella Knee Brace

Medi Genumedi Patella Knee Brace

Sale price$159.95
Tax included.


Medi Genumedi PSS Knee Brace - Patella Tendinitis "Jumpers Knee" Support

The Genumedi PSS is knee support for reliable guidance and stabilisation of the knee joint and to relieve tension on the patellar ligament (tendon) insertion. The compressive knit improves proprioception and sensorimotor function of the knee. The tendon pad with silicone dot coating stimulates the patellar ligament.

The Genumedi PSS Knee Brace is perfect for Basketball, Netball, Volleyball & Running.

Injury Protection & Prevention:

  • Patellar tendinitis (Jumper's Knee)
  • Osgood-Schlatter disease
  • Patellofemoral pain syndrome
  • Chondropathia patellae
  • Chondromalacia patellae
  • Retropatellar arthrosis
  • Patellar maltracking
  • Plica syndrome

How does it work?/Mode of action

The silicone pads in the Genumedi PSS relieve the pressure on the kneecap and, in conjunction with the knitted fabric's compression, produce a massaging effect. This effect encourages circulation through the joint and therefore helps reduce swelling and effusions and alleviate irritation and pain. It simultaneously helps improve muscular control and the body's own stabilisation of the knee joint. The pressure applied by the additional belt strap and the pad under it reduces tension on the patellar tendon thus creating relief for the tendon insertions and alleviating pain.

Supports are most beneficial during physical activity.

Donning/fitting instructions

Open the two belt straps.

Hold the support with the thumb on the inside at the top end of the side stabilisation rods.

Pull the support over the knee in such a way that the two silicon pads cover the centre of the kneecap without applying any pressure. Make sure when positioning the support that the smaller pad (tendon pad) is located below the kneecap over the patellar tendon.

Now close the front belt strap with your leg slightly bent. Check when doing so that this strap runs over the small pad.

Then close the rear belt strap.

The belt may be cut to the individually required length. To this end, open the Velcro fasteners at the end of the belt and shorten them accordingly.

Then check the support's position again.

To remove it, first, open the two belt straps. Then reach into the support from the bottom end and pull downwards.

Please take care that trained staff instructs you when putting on the support for the first time.

Wearing directions

The support can in principle be worn throughout the day. This must depend on how comfortable the wearer is. Moreover, the knee may not be bent by more than 70° when sitting. The support should be removed for long breaks (e.g. long periods sitting, long drives, or sleeping).

If you suffer excessive pain or discomfort during wear, please take off the product immediately and contact your doctor or specialised shop.

The support is suitable for use in water. After use, please rinse thoroughly.